How to Check Oil in Car Engine Properly

Changing Car engine oil at regular intervals keeps your vehicle engine healthy because oil acts as the lifeblood of your car engine therefore check the oil in the car engine properly is an important factor in keeping the engine performance to the optimum. The principal function of the car engine oil is to lubricate and cool moving internal parts of the engine and protect them from wearing out too quickly. If the internal moving parts are not lubricated properly which makes these parts grind with each other and cause really expensive damage.

The engine oil lubrication is also helpful in preventing dirt sludge formation and keeps the engine clean. If you don’t change your car engine oil frequently then these dirt clots cause obstruction in proper lubrication inside the engine and can cause serious damage like replacement of the whole engine in the future however fresh oil prevents dirt sludge’s if changed at recommended intervals by automobile manufacturers. Checking the oil in a car engine properly is quite an easy and quick procedure you don’t need to be a mechanic to check the oil in a car engine. All you need is a car owner manual if you have never done an oil engine check before and a towel to clean dipstick if you are checking the oil in car engine manually depending on car model because some modern cars of today’s era have engine oil monitory sensors that give an indication of car engine oil on the infotainment system of the car.

When to Check Oil in Car Engine?

Check the oil level in the engine once a week at the start for one month so you will know how many times car engine oil takes to get depleted completely. once you learn that you can change the frequency to once a month. Car engine oil change mostly occurs at approximately 3,000 to 5,000 miles (4,828 to 8,047 Kilometers) depending on what kind of vehicle you have and how much you drive daily. If you learn you check the oil in car engine properly then you are able to save both engine and your money spend on maintenance of the vehicle.

Here are the Following Steps You Need to Keep in Mind While Checking Oil in a Car Engine:

(1) Get Ready for Examine:

If you want to check the car engine oil by yourself make sure that the car engine is off and parked on ground level with parking brakes on. Don’t try to check oil in car engine when it is hot because the chances of getting burned increase if you get in contact with hot engine parts unintentionally. You need to lift the hood, if you don’t know then consult with the owner manual. Most cars have a bonnet release lever on the dashboard of the vehicle which you need to unlatch before raising the car bonnet.

(2) Find the Dipstick:

The dipstick is very easy to spot mostly on old models of cars. It has an orange or yellow colored handle with a symbol of an oil can.

(3) Pull out the Dipstick:

After locating the dipstick the next step is to pull the dipstick out of the engine that it is housed in. Due to its long length, it’s like pulling a sword from a sheath. Clean the dipstick with a towel and wipe off any oil left on the dipstick. There are two lines at the end of the dipstick

Upper Line: The upper line indicates that the engine oil tank is full up to the crankcase

Lower Line: The Lower line donates that the oil level in the engine is a quart low.

Depending on the models or brand of the vehicles some dipsticks are also marked with symbols like add or full.

(4) Note Oil Level in Engine:

In order to note the oil level, you need to re-insert the dipstick into the house slowly and push all way down and leave for a very short interval, withdraw the dipstick from the tube and look closely at the tips of the dipstick. If the oil level is between the lines of the dipstick (upper and lower as mentioned above) then the level of oil in the engine is normal and if the level is below or on the lower line then it is required to add more oil.

(5) Recheck the Oil Level:

If your vehicle oil level was below or on the lower line and you added a quart of oil then wait for a few minutes so that the oil run down into the crankcase and then check it again with the same process which I mentioned above and ensure that the oil level stays between the two lines (upper & lower). The oil level doesn’t need to be on a high level (upper line) to lubricate the whole engine to run safely.